Equipment and General Information

PERSONAL PROTECTIVE EQUIPMENT REQUIRED	GENERAL ITEMS	PROPER LIFTING PROCEDURES
1. HARD HAT	1. ENSURE THAT ALL PERSONNEL ARE PRESENT FOR JSA.	1. ENSURE HAND SIGNALES ARE ESTABLISHED & UNDERSTOOD BETWEEN THE FLAGGERS & CRANE-OPERATORS/AIR HOIST OPERATOR
2. SAFETY GLASSES (DAY AND NIGHT)	2. CLEAN WORK AREA AND REMOVE ANY SLIP, TRIP, AND FALL HAZARDS	2. USE A TAG-LINE ON ALL SUSPENDED, MOVING LOADS
3. STEEL-TOE FOOTWEAR	3. ALL PERSONNEL SHOULD PLAN AND COMMUNICATE ESCAPE ROUTES	3. DO NOT STAND UNDER SUSPENDED LOADS
4. WORK GLOVES	4. REPORT ANY UNSAFE ACTS OR CONDITIONS IMMEDIATELY	4. STAY CLEAR OF ALL MOVING LOADS AND AVOID PINCH POINT AREAS
5. GOGGLES/FACE SHIELD (WHEN REQUIRED)	5. REPORT ALL INCIDENTS & NEAR MISSESL IMMEDIATELY	5. MAKE SURE LIFTING GEAR IS PROPERLY RATED, INSPECTED, USED AND SECURED WHEN LIFTING ANY LOAD
6. NON-PERMEABLE ATTIRE (WHEN REQUIRED)	6. BE FAMILIAR WITH LOCATION OF EMERGENCY SHUT-DOWN DEVICES	6. DO NOT USE V-DOOR STAIRS DURING CASING OPERATIONS
7. FALL PROTECTION (WHEN REQUIRED)	7. DRILLER & ANY OPERATORS OF HOISTING EQUIPMENT SHOULD NOT BE DISTURBED DURING OPERATION	7. ONLY ONE PERSON SHOULD BE DESIGNATED AS A FLAGGER
8. FRC ATTIRE	8. USE PROPER MANUAL LIFTING TECHNIQUES

HAZARD ANALYSIS

STEP SEQUENCE OF JOB PROCEDURES	POTENTIAL HAZARDS (SPECIFIC)	ACTIONS TO REDUCE/ELIMINATE HAZARDS
● TEST FIT CASING RUNNING TOOLS, INSPECT AND COUNT CASING ON PIPE RACK	● ITEMS FALLING OFF OF RIG FLOOR COULD LAND INSIDE BUFFER ZONE OR HAVE THE POTENTIAL OF STRIKING PERSONNEL	● COMMUNICATE WITH RIG CREW WHERE YOUR WORK WILL BE PERFORMED
● INSPECT CASING TONGS FOR FITMENT OF TORQUE MONITORING EQUIPMENT	● RIG SITE TRAFFIC EITHER FROM TRUCKS, MAN LIFTS, OR FORKLIFTS COULD RUN OVER OR PIN PERSONNEL BETWEEN VEHICLE OR PIPE RACK	● STAY OUT OF THE BUFFER ZONE WHILE SKATE OF THE CATWALK IS IN OPERATION OR IN THE AIR ● WHEN VEHICLES OR LIFTS ARE NEARBY, MAKE YOUR PRESENCE KNOWN AND STAND CLEAR FROM VEHICLE OPERATIONS